The prop end points can be automatically hooked to the ground, an arbitrary interface or opening (tunnel lining). These points are then automatically positioned in to the intersections of the prop line determined by the input points and the selected lines. The prop can also be introduced directly by specifying coordinates of the two end points.
Props are represented by elastic compressive bar element with constant normal stiffness. The props can sustain only compressive load. When found in tension they are removed from the analysis.
The prop is linked to the finite element mesh in its two end points. No interaction is considered between the soil and the prop along its length when places into the soil.
Props are defined by their starting and end points and by their stiffness. The program automatically links the prop element degrees of freedom to the actual degrees of freedom of the predefined finite element mesh. Therefore, the prop can be introduced anywhere in the structure.
The prop stiffness is specified in terms of the elastic modulus and its area. The program makes also possible to enter the prop diameter - the area is then determined automatically.
In subsequent stages the prop cannot be edited - it can be either removed or input again.
Props - Analysis